•  
  • How to Apply

How to Apply

Applying Colour Shield PPS is very easy.

Depending on the vehicle size, the entire application process can take as little as one hour. Please see the following instructions for applying Colour Shield.

Method #1 - Manual Application

Wash vehicle normally to remove all dirt.

Pour contents of Polarizing Wash Solution into 4 Litre's. of hot water and then mix.

Wash painted/gel coated surfaces with the Polarizing Wash Solution.

Rinse and wipe off Polarizing Wash Solution from applied surfaces until completely removed. Dry with a soft clean cloth or chamois. (See the step one video)

Once the painted/gel coated surfaces are completely dry, move vehicle, boat, or aircraft to a shaded area.

Apply 2 small coin sized dabs of the Paint Protection Coating to a new foam applicator and apply to 1 sq meter section at the time in circular motion and repeat this step until all said surfaces are covered.

Use a clean cloth or terry cloth to remove hazed Paint Protection Coating at the point you began the application. (See the step two video shows machine & manual application).

Note - You can also apply a second coat on the horizontal surfaces such as hood and roof. We recommend using a little masking tape on the edge of black rubber or matted surfaces.

You're done!


Method #2 - Using Orbital Polisher/Buffer

Wash vehicle normally to remove all dirt.

Pour contents of Polarizing Wash Solution into approximately 4 Litres. of hot water then mix.

Wash painted/gel coated surfaces with the Polarizing Wash Solution.

Rinse and wipe off Polarizing Wash Solution from applied surfaces until completely removed. Dry with a soft clean cloth or chamois. (See the step one video)

Once the painted/gel coated surfaces are completely dry, move vehicle, boat, or aircraft to a shaded area.

Apply 2 small coin sized dabs of the Paint Protection Coating to a new De-luxe Foam Applicator and apply to 1 sq meter section at the time in circular motion and repeat this step until all said surfaces are covered.

Buff off vehicle with an Orbital Polisher and a finishing pad, use the machine the lowest speed setting. (Approx. 1800 RPM). (See the step two video).

Note - You can also apply a second coat on the horizontal surfaces such as hood and roof. We recommend using a little masking tape on the edge of black rubber or matted surfaces.

You're done!


Note: The step 1 video talks of paint contaminant removal, further product information including a detailed video can be seen in the Paint Cleaning Kit or by following this link.